Nextar M930 User Manual download pdf (Page 7)

In radio mode, press the ST briefly to select stereo or mono sound mode.

22. CLOCK BUTTON

Press the CLK button briefly to display time for 5 seconds on the display, and

then returns to its previous display unless the button is pressed again.

Then press the CLK button and hold for more than 1 seconds until the real time

flashes on the display.

Then you can adjust HOUR or MINUTE by pressing the V.UP(+) and V.DN(-)

button, respectively.

23. LOUDNESS BUTTON

When press shortly, the LOUD mode is turned on, its to enhance the bass sound

effect when the volume level is low. Press again to cancel the loudness effect.

24. SCAN BUTTON

Press the SCN button to scan the radio frequency. If a valid signal has

detected, the current frequency will be hold and blinked for 5 seconds,

then press SCN again to stop scan and remain the current frequency;

otherwise, the radio will go on to scan the other radio frequency fiver

seconds later.

Note:

1.Make sure use a speaker with 4 ohm load impedance.

2.Do not make the auto antenna wire and ground touch each other

E 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

No comments

Nextar M930 User Manual Page 7